This ensures that the printer retains its settings and is ready for the next contract to be loaded for printing. Īfter selecting the proper form in the list, and printing to the Okidata printer, be sure to press the FF/LOAD button. If the ALARM light does not turn on after the paper is ejected, press FF/LOAD. The ALARM light must be off when the paper is loaded and on when there is no paper in the printer. The top of the paper should then be even with the red line or no more than 1/8" above it. Let go of the buttons when the cartridge stops moving, load a regular sheet of paper, then press and hold SHIFT + LF until the paper stops moving. To do so, remove all paper, turn off the printer, then hold the PARK and QUIET buttons on the front of the printer as the printer is turned on. If the paper comes up below the red line, the Top Of Form may need to be reset. These instructions only cover setting up the okidata microline 320 turbo printer for use with deskmanager. Receipts, for the generic oki microline 390/391 turbo printer.
Appears only when the microline standard emulation is selected. When first loading a pre-printed form into the Okidata ML 320 Turbo, be sure that the form loads in straight and that the top of the form is even with the red line on the clear plastic piece, or sometimes even up to 1/8' above it.
Turning the side dial with the printer on will change the settings on the printer and it will not align properly until set up again. This includes explanations of all the parts, how to align the paper guides, how to replace the ink ribbon. If the printer has a paper jam or pushing FF/LOAD does not eject the paper, be sure to TURN OFF the printer before attempting to remove the paper. If the paper loads crookedly or does not reach the red line, press FF/LOAD to eject the paper, then try again to reload the paper. When first loading a pre-printed form into the Okidata ML 320 Turbo, be sure that the form loads in straight and that the top of the form is even with the red line on the clear plastic piece, or sometimes even up to 1/8" above it. Please call Frazer at 1-88 to obtain the correct version of the form.
If either the Code or Version do not match what is printed on the contract, the form may not align properly in places. To print a pre-printed document, confirm that the Form Code and Revision Date on the form itself matches the form selected in the screen. Be sure that a setup of the Okidata printer has been completed.